Configuring the Client

You need a few pieces of information to configure the client and server. This documentation is just for the client side.

  1. Install wireguard and wireguard-tools

    sudo apt-get install wireguard wireguard-tools
    
  2. Generate a public and private key. This can be done on any system that has "wireguard-tools" installed

    wg genkey | tee privatekey | wg pubkey > publickey
    

    The private key goes to the client, the public key goes to the Wireguard server configurations. See the Configuring PFSense section for details on where to use this Public Key.

  3. Start with a basic Wireguard template, save as wg0.conf

    [Interface]
    PrivateKey = <Client Private Key from Step 2>
    ListenPort = 51820
    Address = 192.168.50.<NEXT FREE IP>/24
    DNS = 192.168.1.1 #DNS Server available to the network
    
    [Peer]
    PublicKey = <Tunnel Public Key from Wireguard Server>
    AllowedIPs = 192.168.50.0/24, 192.168.3.0/24, 192.168.1.0/24 # Comma delimited list of networks/hosts to give client routes to
    Endpoint = <Wireguard Public IP Endpoint>:51820
    
  4. In Ubuntu's case, you must link the resolvectl binary to the resolvconf binary that wg-quick assumes is used.

    sudo ln -s /usr/bin/resolvectl /usr/local/bin/resolvconf
    
  5. To test the configuration:

    wg-quick up ./wg0.conf
    ping 192.168.50.1
    ip route # Look for routes that go through wg0 interfaces
    wg-quick down ./wg0.conf
    
  6. Make the configuration persistent on the client: Then move your configuration file to the /etc/wireguard/ directory to enable an auto startup of the VPN on system boot.

    sudo mv ./wg0.conf /etc/wireguard/wg0.conf
    sudo systemctl enable wg-quick@wg0.service
    sudo systemctl daemon-reload
    sudo systemctl start wg-quick@wg0
    

Revision #7
Created 4 January 2024 22:21:34 by Tokugero
Updated 13 February 2024 17:42:18 by Tokugero